TruDesign - Vented Loop | With Tail | Nylon (Fiberglass reinforced)

 

Designed and made in New Zealand, TruDesign Vented Loops are the superior composite siphon-break solution for marine applications. Vented Loops prevent water siphoning back into a vessel and thereby guard against accidental flooding and sinking. Vented loops are used predominantly in toilet to overboard applications, toilet inlet applications and holding tank to overboard applications. They can also be used in genset or small engine inlet cooling water systems. The simple one way breather valve at the top of the vented loop allows air to enter the line when not in use, thereby preventing siphoning - and yet seals when water or waste passes through the loop. The duckbill one way valve is designed to seal even when particles are present in the fluid.

 

 

 

If the valve is damaged, we can offer you a service kit. The service kit contains a spare valve, cap and a pin for clearing the port in the top of the vented loop.

 

For Electric Toilet applications a Solenoid controlled Vented Loop should be used as this

allows the vent to be switched to fully closed during flush cycle. Allowing greater flow of

water by eliminating air entering the system when an electric toilet is in flush mode. The

solenoid used is normally open, requiring power only to close the valve. See Product

Information sheet – Vented Loop with Solenoid.

CLICK HERE to go to the Solenoid controled Vented Loop.

 

Trudesign supplies a wide range of products for the maritime sector. They are known for their high quality. You'll likely find many Tru Design products on your boat.

All products are manufactured in New Zealand using the latest, highly impact-resistant composite plastic materials. These are designed to meet the demands of the modern boating industry and comply with strict ISO marine standards.

 

General product information:

 

Product code: